HP A6604 Installation Manual page 26

Figure 1-19 Interface module slots on FIP-100
The numbers 1 through 4 in
Maximum interface modules provided by FIP-100s in full configuration
Table 1-19 Maximum interface modules provided by FIP-100s in full configuration
Interface
module
FIP-100
MIMs
HIMs
FIP-110
Introduction
The FIP-110 supports MIMs only. It provides high-density narrowband aggregation, and hence
can protect legacy investment. The FIP-110 supports four MIMs at the same time.
Figure 1-20 Front view of the FIP-110
(1) Slot 1
(3) Slot 3
(5) OPEN BOOK sign
(7) Combo interface 1
"OPEN BOOK" sign – Refer to related sections when performing the following operations:
Operation
Plug/unplug an FIP-110
Plug/unplug an MIM
Connect an Ethernet cable
Connect an optical fiber
Figure 1-19 represent Slot 1 through Slot 4 respectively.
One RPE-X1
A6604 A6608 A6604
2 4 2
8 16 8
Not supported
"Installing and Removing an FIP" in Chapter 4 "Installing the Router"
"Installing and Removing a MIM" in Chapter 4 "Installing the Router"
"Connecting the Management Ethernet Interface" and "Connecting Ethernet
Cables" in Chapter 4 "Installing the Router"
"Connecting an optical Ethernet interface" in Chapter 4 "Installing the Router"
Two RPE-X1s One RSE-X1
A6608 A6604
4 Not supported
16 —
(2) Slot 2
(4) Slot 4
(6) Combo interface 0
Reference
Two RSE-X1s
A6608 A6604 A6608