HP A6604 Installation Manual page 78

Disconnect the power supply to the router. Connect the RJ-45 connector of the console cable to Disconnect the power supply to the router. Connect the RJ
the console port on the router, and the DB the console port on the router, and the DB-9 (female) connector to the serial interface on the
configuration terminal.
Step3 Power on the router after verifying the connection. Power on the router after verifying the connection.
Verify the connection and power on the router. The configuration terminal displays the startup Verify the connection and power on the router. The configuration terminal displays the startup Verify the connection and power on the router. The configuration terminal displays the startup
banner of the router if the connection is correct. For details, refer to "Router Power banner of the router if the connection is
Chapter 5 "Starting and Configuring the Router". Chapter 5 "Starting and Configuring the Router".
A console cable is connected in the same way for both the A6604 and the A6608 A console cable is connected in the same way for both the
figure shows how to connect a console cable for the A6608. figure shows how to connect a console cable for the
Figure 4-36 Connect the console cable
(1) Console port
(4) DB-9 (female) connector
Connecting the AUX Port to a Modem Connecting the AUX Port to a Modem
The AUX port is usually used for remote The AUX port is usually used for remote configuration or dial backup. In this case, you need to
connect the local modem to the remote modem through PSTN and then to the remote device. connect the local modem to the remote modem through PSTN and then to the remote device. connect the local modem to the remote modem through PSTN and then to the remote device.
Follow these steps to connect the AUX port with an AUX cable. Follow these steps to connect the AUX port with an AUX cable.
Step1 Plug the RJ-45 connector of an AUX 45 connector of an AUX cable into the AUX port on the router.
Step2 Plug the DB-25 (male) or DB-
An AUX cable is connected to a modem in the same way for both the A6604 An AUX cable is connected to a modem in the same way for both the
The following figure shows how to connect an AUX cable for the
Connect the console cable
(2) RJ-45 connector
9 (female) connector
-9 (male) connector into the serial interface on the analog modem. 9 (male) connector into the serial interface on the analog modem.
ws how to connect an AUX cable for the A6608.
45 connector of the console cable to
correct. For details, refer to "Router Power-on" in
(3) Serial interface on the configuration terminal (3) Serial interface on the configuration terminal
(5) Console cable
configuration or dial backup. In this case, you need to
to the serial interface on the
A6608. The following
A6604 and the A6608.