HP A6604 Installation Manual page 69

Figure 4-22 Interior structure of the FIP
(1) Positioning holes
(3) Release latch
(5) Memory module
(7) Bridge heatsink 2
(9) Power connector
Figure 4-23 Interior structure of the FIP
(1) Positioning holes
(3) Memory module slot (3) Memory module slot
(5) CPU heatsink
(7) Power connector
Installing a FIP
The following describes how to install a FIP
Step1 Face the front panel of the router. Face the front panel of the router.
Step2 Locate the slot where you will install the FIP, and remove the blank panel from the position. For Locate the slot where you will install the FIP, and remove the blank panel from the position. For Locate the slot where you will install the FIP, and remove the blank panel from the position. For
how to remove a blank panel, refer t how to remove a blank panel, refer to
Step3 Gently push the FIP (with the components facing left) into the slot along the slide rails vertically Gently push the FIP (with the components facing left) into the slot along the slide rails vertically Gently push the FIP (with the components facing left) into the slot along the slide rails vertically
until positioning pins on the backplane are seated in the positioning holes, and then push the until positioning pins on the backplane are seated in the positioning holes, and then push the until positioning pins on the backplane are seated in the positioning holes, and then push the
ejector levers inward to lock the board in position.
Interior structure of the FIP-200
Interior structure of the FIP-210
to install a FIP-200. You can install FIPs in a similar way.
nward to lock the board in position.
(2) Bridge heatsink 1
(4) Memory module slot (4) Memory module slot
(6) CPU heatsink
(8) Bus connectors
(2) Release latch
(4) Memory module
(6) Bus connectors
200. You can install FIPs in a similar way.
"Installing and Removing a Blank Panel" on page 4 " on page 4-35.