Table of Contents
Advertisement
Smt4EN-Ad-F_FM.book Page 90 Friday, December 8, 2000 3:42 PM
Key Operator Settings
Printing the Forwarding Mark
You can have a mark stamped on doc-
uments to indicate that they have
been forwarded.
At the forwarding destination this
can help distinguish between stan-
dard faxes and faxes that have been
forwarded.
Note
❒ You can turn the Forwarding Mark
on or off with the User Parameters.
See P.95 "User Parameters" (switch
02, bit 0). When shipped, this fea-
ture is turned on.
Printing the Specified Sender List
You can check which Specified Send-
ers are registered for a Forwarding
Address.
Follow the steps below to print this
7
list.
A
Make sure that the machine is in
standby mode.
B
Press the { { { { User Tools} } } } key.
C
Press 0 0 0 0 or 1 1 1 1 to display "4. Key
Op. Tools".
User Tools Main Menu
4.Key Op. Tools
D
Press the { { { { OK} } } } key, and then
press { { { { 2} } } } { { { { 2} } } } { { { { 2} } } } { { { { 2} } } } .
E
Press the { { { { OK} } } } key.
F
Press 0 0 0 0 or 1 1 1 1 to display "7. For-
warding".
Key Op. Tools:
7.Forwarding
90
Printed Matters
G
Press the { { { { OK} } } } key.
H
Press 0 0 0 0 or 1 1 1 1 to display "4. Print
SenderList".
Forwarding:
4.Print SenderListhi
I
Press the { { { { OK} } } } key.
J
Press the { { { { Start} } } } key.
The list is printed.
K
Press the { { { { User Tools} } } } key.
The machine returns to standby
mode.
hi
hi
Advertisement
Table of Contents
