Table of Contents
Advertisement
Smt4EN-Ad-F_FM.book Page 15 Friday, December 8, 2000 3:42 PM
SEP Code Polling Reception
If you want to receive a message
stored in the memory of another par-
ty's fax machine, use this feature. The
machine will receive the message
with the SEP and PWD code that
matches the SEP and PWD code you
enter in the following procedure.
Note
❒ You can enter up to 20 characters
from the following: digits from 0 to
9, #, *, and spaces.
❒ If you make a mistake, press the
{Clear} key and try again.
A
Press the { { { { Trans. Option} } } } key.
B
Press 0 0 0 0 or 1 1 1 1 until "9. RX with
SEP" is displayed.
Trans. Option
9.RX with SEP
C
Press the { { { { OK} } } } key.
D
Press 0 0 0 0 or 1 1 1 1 to turn SEP Code
Reception "On".
RX with SEP:
[On]
E
Press the { { { { OK} } } } key.
F
Specify the other party's fax number.
Dest.1:
0123456789_kkkkkkkkk
Note
❒ If you used Quick Dial key to
specify a destination that was
registered along with a SEP code,
or if you specified the destination
using Speed Dial, go to step I.
Printed Matters
hi
hi/OK
Off
Press OK
SEP Code Polling Reception
G
Press the { { { { OK} } } } key.
H
Enter the SEP Code with the num-
ber keys.
SEP:
1111_kkkkkkkkkkkkkkk
Note
❒ If you make a mistake, press the
{Clear} key and try again.
I
Press the { { { { OK} } } } key.
J
Press 0 0 0 0 or 1 1 1 1 to select "Yes" or
"No".
Add Dest.?
[Yes]
No
K
Press the { { { { OK} } } } key.
If you selected "Yes", go to step F.
L
Press the { { { { Start} } } } key.
Once the document is received, the
machine returns to standby mode.
Note
❒ You can cancel transmission of
a message set up for SEP Code
Polling Reception. (See P.17
"Canceling Transmission or Re-
ception".)
❒ A Communication Result Re-
port prints out after SEP Code
Polling Reception is set up. You
can use this to confirm the con-
tents of SEP Code Polling Re-
c e p t i o n .
( S e e
"Communication Result Report
(Memory Transmission) (Switch
03, Bit 0)".)
1
Press OK
hi/OK
P . 4 0
15
Advertisement
Table of Contents
