Table of Contents
Advertisement
Smt4EN-Ad-F_FM.book Page 154 Friday, December 8, 2000 3:42 PM
Installation
Connecting to a Telephone Line
RCAUTION: To reduce the risk of fire,
use only No.26 AWG or larger telecom-
munication line cord.
RATTENTION: Pour réduire le risque
d'incendie, utiliser uniquement des
conducteurs de télécommunications
26 AWG ou de section supérieure.
To connect the machine to a tele-
phone line, use a snap-in modular
type connector.
There are similar sockets located at
the rear of the machine.
• TEL1: For the optional handset or
external telephone
• LINE: Telephone line connection
Note
❒ Do not switch the machine on
until everything is connected
properly.
❒ Program the Telephone Line
Type setting. (See P.107 "Line
Type".) If your telephone nor-
mally sends out tones (touch
tone) when dialing, use the TT
setting; if it normally sends out
pulses (rotary dial), use the DP
setting. Also, make sure that the
switch on the handset is set up
10
correctly.
154
Printed Matters
A
Insert the line cable into the sock-
et labeled "LINE".
ZCKH080N.eps
B
Connect the other end of the line
cable to your telephone line.
TSTL020N.eps
Important
❒ In the United States, you are re-
quired by law to program your
phone number identification
(Own Fax Number) into the fax
machine before you connect a
fax machine to the public tele-
phone system. See Chapter 3,
"Initial Settings and Adjust-
ments" in the Basic Features
manual.
TSTL020N
Advertisement
Table of Contents
