Isdn G3/G4 - Ricoh FAX3900L Operating Instructions Manual

Smt4EN-Ad-F_FM.book Page 112 Friday, December 8, 2000 3:42 PM
Key Operator Settings

ISDN G3/G4

You must set the following items
when your machine is connected to
ISDN.
• G4 Terminal ID
• G4 Own Number
• G4 SPID (G4 Own Number 2)
• G4 Sub-Address
• I-G3 Own Fax Number
• I-G3 Own Number
• I-G3 SPID (I-G3 Own Number 2)
• I-G3 Sub-Address
G4 Terminal ID, G4 Own Number, G4
SPID (G4 Own Number 2), and the G4
Sub-Address must be set when using
G4 communications.
I-G3 Own Fax Number, I-G3 Own
Number, I-G3 SPID (I-G3 Own Num-
ber 2), and the I-G3 Sub-Address
7
must be set when using G3 communi-
cations.
❖ ❖ ❖ ❖ Programming the G4 Terminal ID
If your machine uses Group 4
mode through the ISDN, G4 Ter-
minal ID appears on the other ter-
minal's display and is printed in
reports.
• You can store digits and pauses
as the G4 Own Number.
❖ ❖ ❖ ❖ Programming G4 Own Number
Program the G4 Own Number for
ISDN.
Separate the telephone number it-
self from the area or exchange code
by inserting a pause.
Note
❒ This must be programmed
when your machine is connect-
ed to ISDN.
112
Printed Matters
❖ ❖ ❖ ❖ Programming G4 SPID (G4 Own Num-
ber 2)
When you have two units connect-
ed to the same line, enter the I-G4
SPID number.
If "ISDN Directory Number Select
(SPID)" in the User Parameters is
turned off, the display shows "G4
Own Number 2" instead of "G4
SPID". These settings are identical.
❖ ❖ ❖ ❖ Programming the G4 Sub-address
When multiple terminals (faxes,
digital phones, and so on) are con-
nected to the same line, program a
sub-address for each terminal.
Note
❒ You can enter up to 4 digits.
❒ You can enter numbers from 0
to 9999.
❖ ❖ ❖ ❖ Programming the I-G3 Own Fax Num-
ber
If your machine uses Group 3
mode through the ISDN, the G3
Own Fax Number appears on the
other terminal's display and is
printed in reports.
Note
❒ You can enter numbers, the +
symbol, and spaces.
❒ You can enter up to 20 digits.
❖ ❖ ❖ ❖ Programming I-G3 Own Number
You must program I-G3 Own
Number.
• You can store digits and pauses
as the G3 Own Number.