Table of Contents
Advertisement
Smt4EN-Ad-F_FM.book Page 107 Friday, December 8, 2000 3:42 PM
Line Type
You must register the Line Type be-
fore you connect the machine to the
line.
Note
❒ By default, Line Type is set to
"Tone".
❒ This setting has no effect if you fax
machine is connected to only an
ISDN line.
Limitation
❒ This function will not work if your
machine is connected to ISDN
only.
• If you do not correctly set the
Line Type, you will be able to
receive messages, but you may
not be able to send them.
• If you do not know the type of
line you are connected to, select
"Tone" and dial a trial number.
If the connection was success-
ful, your Line Type is "Tone", if
it did not, set the Line Type to
"Pulse" and dial a trial number.
If the connection was success-
ful, your Line Type is "Pulse".
To register the Line Type, perform the
following procedure.
Note
❒ You can edit the registered Line
Type by performing the steps for
registering the Line Type in the fol-
lowing procedure.
A
Make sure that the machine is in
standby mode.
B
Press the { { { { User Tools} } } } key.
Printed Matters
C
Press 0 0 0 0 or 1 1 1 1 to display "4. Key
Op. Tools".
User Tools Main Menu
4.Key Op. Tools
D
Press the { { { { OK} } } } key.
E
Press { { { { 2} } } } { { { { 2} } } } { { { { 2} } } } { { { { 2} } } } , and then
press the { { { { OK} } } } key.
F
Press 0 0 0 0 or 1 1 1 1 to display "13. Line
Type".
Key Op. Tools:
13.Line Type
G
Press the { { { { OK} } } } key.
H
Press 0 0 0 0 or 1 1 1 1 and select "Tone" or
"Pulse".
Line Type:
Pulse [Tone]
I
Press the { { { { OK} } } } key.
J
Press the { { { { User Tools} } } } key.
The machine returns to standby
mode.
Line Type
hi
hi
7
hi/OK
107
Advertisement
Table of Contents
