Table of Contents
Advertisement
Smt4EN-Ad-F_FM.book Page 126 Friday, December 8, 2000 3:42 PM
Key Operator Settings
System Parameter Transmission
This feature sends information about
the condition of your machine to your
nearest service representative. Follow
these steps when your service repre-
sentative requests you to.
Important
❒ This information is sent to the des-
tination that has been registered in
your machine by a customer engi-
neer.
• The list is sent from memory
straight to your nearest service
representative.
To send a System Parameter Trans-
mission, perform the following proce-
dure.
A
Make sure that the machine is in
standby mode.
B
7
Press the { { { { User Tools} } } } key.
C
Press 0 0 0 0 or 1 1 1 1 to display "4. Key
Op. Tools".
User Tools Main Menu
4.Key Op. Tools
D
Press the { { { { OK} } } } key.
E
Press { { { { 2} } } } { { { { 2} } } } { { { { 2} } } } { { { { 2} } } } , and then
press the { { { { OK} } } } key.
F
Press 0 0 0 0 or 1 1 1 1 to display "24. Sys-
tem Param. TX".
Key Op. Tools:
24.System Param.TXhi
126
Printed Matters
G
Press the { { { { OK} } } } key.
H
Press the { { { { Start} } } } key.
The destination fax number set by
the custom er engineer is dis-
played.
Once transmission has finished,
the machine returns to standby
mode.
hi
Advertisement
Table of Contents
