Operation
4.22 Moving to the reference position
The reference position is necessary in order to obtain a defined initial
position.
To move to the reference position:
1. Switch on the machine.
The control is initialized.
2. Press the left pedal back.
The reference run starts.
4.23 Performing a quick stop
To perform a quick stop:
1. Press the left pedal back.
The positioning sequence / cycle process is stopped immediately.
2. Press the left pedal back again.
The transport carriage moves to its rear end position.
Operating Instructions 755 B, 756 B/F - 00.0 - 02/2021
The control checks whether the transport carriage is at its rear end
position. If not, the display shows the message Reference run:
Warning 9000
The transport carriage moves to its rear end position.
The display shows the following message:
Warning 9601
.
.
53