Setting the drive
6.2.2 Adjusting the reference position of the handwheel
Correct setting
The reference position is 105° on the handwheel scale (2).
Setting steps
1. Select parameter setting mode in the field OP1000 (1) and set the param-
2. Manually turn the handwheel (2) at least one revolution and turn it to
3. Acknowledge the set position by pressing the OK button.
4. To exit parameter setting mode, press the Esc key.
5. Switch the machine on and off.
Service instructions 967 - 00.0 - 12/2014
eter t 08 10 ( DAC basic/classic Service instructions).
105° on the scale ( page 20).
29