Table of Contents
Advertisement
Setup
To roll the machine:
1. To transport the machine on casters, loosen the nuts (1) of the stand
2. When transport is complete, loosen the stand feet (3) until the
3. Tighten the nuts (1).
7.2.3 Removing the transport locks
Remove all transport locks before setting up the machine.
All moving parts must be unlocked:
Important
If you wish to transport the machine to a different location, you have to
attach the transport locks again.
When removing/fitting the transport locks, also observe the information
given in the supplementary sheet included with the machine.
Operating Instructions 755 B, 756 B/F - 00.0 - 02/2021
feet (3) and screw in the stand feet (3).
casters (2) lift off the ground.
• Transport carriage
• Method plate
• Corner knife station
• Middle knife
• Feeder
• Assembly groups, e. g. stacker
307
Advertisement
Table of Contents
