Table of Contents
Advertisement
7.2.4 Adjusting the working height
The working height can be adjusted between 797 mm and 1138 mm
(measured to the upper edge of the tabletop).
The sewing unit has been set to the lowest working height of 797 mm at
the factory.
Fig. 253: Adjusting the working height
(1) - Screws
To set the desired working height:
1. Loosen the screws (1).
2. Set the tabletop to the desired working height.
3. To avoid jamming, slide the stand tubes in or out evenly on both sides.
4. Tighten the screws (1).
308
WARNING
Risk of injury from unstable footing!
Tipping of the machine.
Use caution when loosening the screws.
①
Do not loosen the screws (1) all the way.
Operating Instructions 755 B, 756 B/F - 00.0 - 02/2021
Setup
①
Advertisement
Table of Contents
