4.16.3 Setting up single pipe
Fig. 33: Setting up single pipe
(3) - Stops
To set up single pipe:
1. You switch and set the transport clamps from double pipe to single pipe
2. Position the piping strip at the front or rear stop (3).
3. Position the piping strip at the center stop (4).
4. Start sewing.
44
③
(also requires a change of the folder tools!) at the OP7000 control
panel. Program parameters > Process of transport
clamp > Transport clamp quick adjustment ( p. 167).
(4) - Center stop
Operating Instructions 755 B, 756 B/F - 00.0 - 02/2021
Operation
④