Method F - Dürkopp Adler 755 B Operating Instructions Manual

Operation
With a press of the
up piping strip can be released again.

4.28.3 Method F

Working method F allows for the alignment of the flap as per the pattern.
This eliminates the need to mark the flap manually.
You switch on method F at the OP7000 control panel.
Program parameters > Pattern matching ( p. 184).
Positioning points for left or right jacket front parts
Fig. 77: Sewing pocket openings with flap in jacket front parts (1)
(1) - Dart
(2) - Right jacket front part
(3) - Left jacket front part
(4) - Light spot seam end
Important
To achieve the best possible result when sewing the flap to the jacket front
part, you will need to ensure a good match of stripes and checks even
while preparing the sewing materials.
The alignment needed to match checks and stripes should always be
made in the front to middle section of the flap relative to the jacket front
part.
Operating Instructions 755 B, 756 B/F - 00.0 - 02/2021
button on the start screen, the previously picked-
②
③
① ⑦
①
(5) - Light spot dart position
(6) - Light spot seam beginning
(7) - Light spot middle knife incision
(8) - Light spot dart position
⑥
⑤
⑧
④
⑦
89