Table of Contents
Advertisement
Operation
4.27.8 Automatic incision device for piping ends
With the automatic incision device for piping ends the piping strip end is
cut open from the middle knife incision to the piping ends. The cutting
areas are adapted to the respective seam length as well as to the
positioning point.
Position of the cutting areas
The setting for the cutting position and the cutting length is made using
the OP7000 control panel. Program parameters > Adjust piping
knife ( p. 181).
Fig. 57: Position of the cutting areas
T
L
S
Ü
The total length L of a piping incision can be programmed and is preset.
It can be changed as needed. The programmable value S indicates
the length of the cut within the pocket length T.
The value S is preset and can be adjusted in the menu Adjust piping
knife
Operating Instructions 755 B, 756 B/F - 00.0 - 02/2021
Pocket length
programmable cutting length of the piping knife
Cutting length within the pocket length
Cut-open piping projection
(
p. 232).
Seam beginning
Piping strip
Seam end
65
Advertisement
Table of Contents
