Operation
4.17.3 Adjusting the corner knives (multi-functional corner knife
Fig. 37: Adjusting the corner knives (multi-functional corner knife station)
(1) - Screw
(2) - Knife holder
The corner knives are adjusted by stepper motors.
You adjust the corner knife cuts at the OP7000 control panel.
Program parameters > Corner knives ( p. 153).
Checking the cutting pattern
Fig. 38: Checking the cutting pattern
• Straight pocket corners: the right and the left corner knife cuts are
• Slanted pocket corners: the left corner knife cut is offset by +/- 13 mm
Operating Instructions 755 B, 756 B/F - 00.0 - 02/2021
station)
①
②
parallel to one another
relative to the right corner knife cut
(3) - Knife holder
(4) - Screw
④
③
49