Setting Up Double Pipe - Dürkopp Adler 755 B Operating Instructions Manual

Operation
15. Switch on the machine.
 The spindles (1) move back down automatically.
16. Set the software to the correct setting.
You switch and set the transport clamps from double pipe to single pipe
and vice versa at the OP7000 control panel. Program parameters >
Process of transport clamp > Quick clamp adjustment
( p. 167).
Important
If the display shows error message 9014 - warning of collisions, the
software setting for the folder tools is incorrect/not sensible. Check and,
if necessary, correct the setting.

4.16.2 Setting up double pipe

Fig. 32: Setting up double pipe
(1) - lateral stop
To set up double pipe:
1. You switch and set the transport clamps from single pipe to double pipe
2. Position the piping strip at the front or rear stop (2).
3. Position the piping strip at the lateral stop (1).
4. Start sewing.
Operating Instructions 755 B, 756 B/F - 00.0 - 02/2021
①
(also requires a change of the folder tools!) at the OP7000 control
panel. Program parameters > Process of transport
clamp > Transport clamp quick adjustment ( p. 167).
(2) - Stops
②
43