Commissioning - Dürkopp Adler 755 B Operating Instructions Manual

Setup

7.12 Commissioning

You should perform a sewing test when finished setting up the sewing unit.
To perform a sewing test:
1. Supply the machine with compressed air.
2. Insert the power plug.
3. Thread the needle threads ( p. 21).
4. Insert the bobbins ( p. 26).
5. Switch on the machine.
 The control is initialized.
6. Press the left pedal backwards.
 The reference run starts.
The reference run is necessary in order to obtain a defined starting
position of the transport carriage.
7. Select the seam program ( p. 106).
8. Insert the sewing material.
9. Press the left pedal forward.
 The different steps of the positioning procedure are triggered one
Operating Instructions 755 B, 756 B/F - 00.0 - 02/2021
WARNING
Risk of injury from sharp parts and laser light!
Puncture or blindness.
Turn off the main switch before threading needle
thread and hook thread.
Do NOT look directly into the light source of the
laser beam.
NOTICE
Property damage may occur!
Moving the transport carriage without sewing material damages
the transport clamp coating.
Before starting to sew, make sure there is sewing material under
the transport clamps.
The transport carriage moves to its rear end position.
after another.
The sewing procedure is started.
325