Table of Contents
Advertisement
7.2 Moving the feed dog carrier sideways
The feed dog carrier is connected to the stitch regulator gear via the pusher
shaft, and can be moved on this shaft.
Fig. 32: Moving the feed dog carrier
(1) - Threaded pins
(2) - Set collars
To move the feed dog carrier sideways:
1. Execute the service routine Feed dog > Position to
The software is used to define the necessary presettings on
2. Tilt the machine head ( p. 18).
3. Loosen the threaded pins (1).
4. Loosen the threaded pins (3).
5. Loosen the screw (4).
6. Move the feed dog carrier perpendicular to the sewing direction so that
7. Push the set collars (2) toward each other as far as they will go.
Important
Make sure that the pusher shaft is tightened by the set collars and does
not have any axial play.
8. Tighten the screw (4).
9. Tighten the threaded pins (3).
46
①
②
③
needle ( p. 14).
the machine.
the feed dog is exactly in the center of the throat plate cutout.
Adjusting feed dog and needle bar linkage
②
(3) - Threaded pins
(4) - Screw
Service Instructions D867 e-con - 00.0 - 08/2023
④
Advertisement
Table of Contents
