Setting The Handwheel Scale - Dürkopp Adler M-TYPE H867 Service Manual

5 Setting the handwheel scale

Checking the correct setting
Lock the machine in place in the handwheel zero position (

If a different degree number is next to the pointer (2) in the handwheel
zero position (
scale. Otherwise you will not be able to work with the handwheel positions
you need for specific settings.
Figure 12: Setting the handwheel scale
(1) - Screw opening
Setting steps
The handwheel is fastened using two screws, which you can see through
the screw opening (1).
1. Turn the handwheel such that one screw is under the opening (1).
2. Loosen the screw using a 3 mm hex key through the opening (1).
3. Turn the handwheel such that the second screw is under the opening (1).
4. Loosen the screw using a 3 mm hex key through the opening (1).
5. Lock the machine in place in the handwheel zero position (
6. Turn the handwheel scale such that the 0° marking is exactly in the
7. Firmly tighten the screw using a 3 mm hex key through the opening (1).
8. Remove the locking mechanism (
9. Put the handwheel into the 50° position.
10.Firmly tighten the second screw using a 3 mm hex key through the
18
WARNING
Risk of injury
Switch the sewing machine off before you check and set the
position of the handwheel on the arm shaft.
The handwheel is at position 0°.
 page 16), then you will have to reset the graduated
center of the pointer (2).
opening (1).
Setting the handwheel scale
(2) - Pointer

page 17).
Service manual H867 Version 00.0 - 08/2013

page 16):

page 16).