3.
Top feed
3.1
Position of the needle holder with single needle sewing machines
Rule:
The position of the needle holder is to be set according to the picture.
Angular position of
the needle holder
Needle thickness/Nm
1
–
Loosen screw (1) and turn the needle bar with the right groove
edge (2) to the needle bar axis (in sewing direction) and tighten
screw (1).
–
Bring the needle bar to the upper dead center and loosen the
screw of the needle holder through the bore (3) by using an Allen
key of 2.5 mm (4).
–
Turn the needle holder (5) according to the rule and tighten the
screw.
2
70 - 110
EN
4
3
5
17