Installing The Link Mounting Bracket - Toro 30460 Operator's Manual

Figure 5
1. Mower deck
2. Drill three, 1/8 inch pilot
holes and 13/32 inch
diameter holes, here
3. Template with the number
60 in it
5. Install the new blower pivot with 3 bolts (3/8 x 1
inch) and 3 locknuts (3/8 inch) using the drilled holes
(Figure 6).
6. Install the anti-scalp roller to the blower pivot with
the previously remove axle bolt (3/8 x 4-1/2 inches),
spacer, bushing, and flange nut (3/8 inch)
4. Template location on
mower deck
5. Nuts
6. Carriage bolts
(Figure 6).
1. Mower deck 4. Bolt (3/8 x 4-1/2
2. Bolt (3/8 x 1 5. Spacer
inch)
3. Locknut, (3/8 6. Anti-scalp roller 9. Drilled holes
inch)
5
Installing the Link Mounting
Bracket
Parts needed for this procedure:
1 Link mounting bracket
3 Bolt, (3/8 x 1 inch)
3 Flanged locknut, (3/8 inch)
Procedure
Install the link mounting bracket to the rear frame of the
machine with 3 bolts (3/8 x 1 inch) and 3 flanged locknuts
(3/8 inch) (Figure 7).
8
Figure 6
7. Bushing
inch)
8. Blower pivot
assembly