Installing The Mower; Installing The Boot Bracket - Toro Wheel Horse 78200 Operator's Manual

8. Secure left side hitch hook with a clevis pin (3/8 x
1–1/2 in.) and a hairpin cotter (Fig. 11).
9. Install the collector belt onto the the jack shaft pulley
and fully install the collector belt (Fig. 7).
6
4 1
5
m–5953
Figure 11
1. Collector
2. Quick hitch hooks
3. Quick hitch round bar
4. Hitch lever
5. Locking pin

Installing the Mower

For installing the mower, refer to the mower operator's
manual.
Important If extreme low cut height is used, install
mower drive belt in bottom engine pulley.

Installing the Boot Bracket

Note: There are two templates for installing the boot
bracket. Template number 1 is for 42 in. (107 cm) mowers
only and template number 2 is for 48 in. (122 cm) mowers
only.
Installing the Boot Bracket onto 42 in.
(107 cm) Mowers
Note: Use template number 1, in the back of this operator's
manual, for locating holes to drill.
1. Locate and cut out template number 1 [42 in. (107 cm)
mower] as indicated on the template.
2. Remove the existing belt guard (Fig. 12).
3. Place template number 1 on top of the mower and align
it by matching the existing holes in the mower (Fig. 12).
7
2
3
8 9
6. Clevis pin, 3/8 x 1–1/2 in.
7. Hairpin cotter
8. Collector pin
9. Hitch extension
4. Center punch the 2 holes that are to be drilled and
remove the template (Fig. 12).
5. Drill two, 9/32 in. diameter, holes at the marked
locations.
6. Install the boot bracket with 2 bolts (1/4 x 1/2 in.) and 2
flange nuts (1/4 in.) (Fig. 14).
Note: Install the bolt heads on top of the mower.
7. Install the belt guard (Fig. 12).
2
1
2 3
5
4
m-5963
Figure 12
1. Template
2. Hole to drill
3. Existing hole
Installing the Boot Bracket onto 48 in.
(122 cm) Mowers
Note: Use template number 2, in the back of this operators
manual, for locating holes to drill.
1. Locate and cut out template number 2 [48 in. (122 cm)
mower] as indicated on the template.
2. Remove the existing belt guard (Fig. 13).
3. Place template number 2 on top of the mower. Align it
so the notch in the template fits around the
reinforcement plate and the template matches the
existing hole (Fig. 13).
4. Center punch the 2 holes that are to be drilled and
remove the template (Fig. 13).
5. Drill two, 9/32 in. diameter, holes at the marked
locations.
6. Install the boot bracket with 2 bolts (1/4 x 1/2 in.) and 2
flange nuts (1/4 in.) (Fig. 14).
9
6
3
4. Mower
5. Grass deflector
6. Belt guard