Table of Contents
Advertisement
1
Figure 16
1. Self-tapping screw (5/16 x
3/4 inch)
3. Attach the draw-bar decal 1.3 cm (1/2 inch) to the left
of the attachment mount
g030498
Figure 17
1. Draw bar decal
4. Install a bent, flared end of a rod into the keyed slot in
the left side of the machine frame, and move the rod
rearward to seat it in the frame
Note: Repeat this step for the right side of the
machine.
g030497
2
2. Pivot frame
(Figure
17)
1
(Figure
18).
2
1
4
6 5
1. Pivot-frame hole
2. Washer
3. Hairpin cotter
5. Insert the bent ends of the rod into the attachment
mount as shown in
each rod with a washer and hairpin cotter.
3
Assembling the Bagger Top
Parts needed for this procedure:
1
Bagger top
1
Bagger screen
Procedure
1. Turn the bagger top over.
2. Install the screen as shown in
slopes down toward the collection bags.
Note: Make sure the screens snap into place and the
tabs engage the bagger top.
10
3
Figure 18
Left side shown
4. Support rod
5. Keyed slot (existing)
6. Bent, flared end of support
rod
Figure 18
and secure the end of
Figure 19
and that it
g030499
Advertisement
Table of Contents
