Honda HRS216PKA Manual page 98

HRS216PKA • HRS216SKA • HRS216VKA
5. GOVERNOR
DISASSEMBLY/REASSEMBLY
GOVERNOR WEIGHT HOLDER ASSEMBLY
REASSEMBLY:
Before installing, check for wear and damage of the gear.
Check that the weights move freely.
Be sure to install the governor weight before installing the crankshaft.
OIL FILLER CAP /DIPSTICK
GASKET
OIL FILLER EXTENSION
REASSEMBLY:
Hand tighten until the O-ring is
compressed, then bend up the two
lock washer edges to secure the oil
gasket
filler extension.
RIB
GOVERNOR HOLDER SHAFT
LOCK WASHER
REASSEMBLY:
Install the notch over
the rib on the oil pan.
O-RING
OIL PAN
P. 9-19
INSPECTION:
CAM PULLEY/CRANKSHAFT/PISTON/
GOVERNOR HOLDER CLIP
REASSEMBLY:
Insert firmly into the shaft
groove.
6 mm THRUST WASHER
GROOVE
8 mm LOCK PIN
REASSEMBLY:
Install the lock pin
immediately after
installing the governor
arm shaft and move the
shaft over against the
governor slider.
The lock pin must be
installed with the straight
side of the pin against
the groove in the shaft.
CYLINDER BLOCK
GOVERNOR SLIDER
REASSEMBLY:
Spread the governor
weights to install the slider;
then check to be sure the
slider moves smoothly.

6 x 14 FLANGE BOLT (2)
12 N•m (9 lb-ft)
6 mm WASHER
REASSEMBLY:
Install inside the case.
GOVERNOR ARM SHAFT
GOVERNOR ARM SHAFT
GROOVE
LOCK PIN
9-13