Honda HRS216PKA Manual page 109

HANDLE PIPE/CABLES
K6 VKA MODEL
1. Cut the three cable ties securing the brake cable and Smart Drive cable to the handle pipe. Fully loosen the
Smart Drive cable adjuster
2. Remove the 6 mm locking nut, 6 x 45 mm flange bolt, 6 mm plain washer, and the flywheel brake cable
assembly from the handle pipe assembly.
3. Remove the flywheel brake lever from the handle pipe, then from the lever stop.
4. Remove the lock pin; then remove the lever stop from the handle pipe.
5. Remove the four 4 mm self-tapping screws and the upper and lower clutch grips. Carefully remove the
multi-position adjuster and spring.
6. Unsnap and remove the upper and lower bracket covers.
7. Remove the 5 x 37 mm roller pin, the four 4 mm self-tapping screws, and the upper and lower grip brackets.
HANDLE GRIP (2)
REMOVAL/INSTALLATION:
LOWER GRIP BRACKET
LOWER BRACKET COVER
LOWER CLUTCH GRIP
4 mm SELF TAPPING SCREW (8)
LEVER STOP
LOCK PIN
ROPE GUIDE
HANDLE PIPE
10-4
(P. 3-9).
UPPER GRIP BRACKET
P. 10-12
CABLE TIE (3)
HRS216PKA • HRS216SKA • HRS216VKA
UPPER BRACKET COVER
5 x 37 mm
ROLLER PIN
FLYWHEEL BRAKE
CONTROL CABLE
6 mm PLAIN WASHER
6 mm LOCKING NUT
UPPER CLUTCH GRIP
MULTI-POSITION
ADJUSTER
SPRING
SMART DRIVE CABLE
REMOVAL/
INSTALLATION:
(P. 10-13)
FLYWHEEL
BRAKE LEVER
6 x 45 mm
FLANGE BOLT