Honda HRS216PKA Manual page 122

HRS216PKA • HRS216SKA • HRS216VKA
9. Route the Smart Drive cable down through the hole in
the cutter housing.
10. Attach the Smart Drive cable end on the control arm.
11. Push the transmission as shown, align the Smart Drive
cable wire with the cable holder slot, and install the
snap fitting into the cable holder.
12. Rotate the Smart Drive control and confirm that the
lower end of the Smart Drive cable moves the
transmission control arm.
13. Install the belt cover and rear scroll
14. Install new cable ties securing the Smart Drive cable to
the handle pipe.
15. Readjust the Smart Drive cable
16. Start and test the Smart Drive operation.
6. SMART DRIVE DISASSEMBLY AND INSPECTION (VKA TYPE)
1. Confirm the rubber grips do not contact the Smart
Drive handle. Any contact will likely prevent the
control from releasing properly.
2. Loosen the Smart Drive cable adjuster completely
(P. 3-9).
3. Remove the 4 mm screws and separate the upper
and lower grips and multi-position adjuster and
spring.
(P. 11-2).
(P. 3-9).
Viewed from under
the handle pipe.
4 mm
SELF-TAPPING
SCREW (4)
HANDLE PIPE/CABLES
SNAP FITTING
CABLE HOLDER
SMART
DRIVE
CABLE
45 ~ 50 mm
(1.75 ~ 2.0 in)
™
CONTROL
HANDLE SMART DRIVE
GRIP (2) HANDLE
Multi-position adjuster and
spring
TRANSMISSION
CONTROL ARM
Push
45 ~ 50 mm
(1.75 ~ 2.0 in)
RUBBER
GRIP (2)
UPPER
CLUTCH
GRIP
LOWER
CLUTCH
GRIP
10-17