Honda HRS216PKA Manual page 148

HRS216PKA • HRS216SKA • HRS216VKA
K6 VKA MODEL
DRIVEN PULLEY HALVES
REMOVAL
Hold the pinion shaft with a wrench,
and then remove the 10 mm flange
nut.
INSTALLATION:
Align the pulley pins opposite each
other so that they fit into the small
holes of the other pulley half.
12.7 x 22.2 x 6.4 mm
OIL SEAL (2)
12.7 x 28.6 x 6.4 mm
OIL SEAL
TRANSMISSION CASE
INSTALLATION: Use SAE 10W-30
engine oil and fill to the capacity
shown.
The correct oil level should be
18 ~ 20mm (0.71 ~ 0.79 in) from the
top of the transmission case when it is
upside down.
CAPACITY: 65 cc (2.2 oz)
TOP OF
18 ~ 20 mm
CASE
(0.71 ~ 0.79 in)
BELT GUIDE
PINION SHAFT
CASE O-RING
REDUCTION
COVER
TRANSMISSION CONTROL ARM
TRANSMISSION / DRIVE BELT
10 mm FLANGE NUT
39 N•m (29 ft-lb)
PINS
10 x 24 mm HARDENED WASHER
6 x 12 mm
FLANGE BOLT (2)
RETURN SPRING
SMART DRIVE CABLE
6 x 12 mm FLANGE BOLT (4)
8.8 ~ 11.8 N•m (6.5 ~ 8.7 ft-lb)
CABLE HOLDER
12-17