Honda HRS216PKA Manual page 75

FUEL SYSTEM
4. FUEL VALVE/GOVERNOR ARM
DISASSEMBLY/REASSEMBLY
LOW PERMEATION FUEL TUBE WITH
EMISSIONS COMPLIANCE ID NUMBER
4.5 x 110 mm FUEL TUBE
REASSEMBLY:
Inspect for cracks or deterioration before installation, and replace
if necessary.
Only use the correct low permeation fuel tube when replacing.
The fuel tube must contain the emissions-compliance
identification number.
B8 TUBE CLIPS
6 x 14 mm
FLANGE BOLT
6 x 14 mm
FLANGE BOLT
7-16
GOVERNOR ARM/THROTTLE RETURN SPRING
INSTALLATION:
Install the governor rod through the throttle return spring as shown. Connect each to the
governor arm and carburetor throttle arm as shown.
THROTTLE ARM THROTTLE
GOVERNOR SPRING
REASSEMBLY: Install
with the short end side
toward the governor arm.
FUEL VALVE
BRACKET
FUEL VALVE
HRS216PKA • HRS216SKA • HRS216VKA
SERVICE BULLETIN #106 =>
GOVERNOR ROD
LONG END
LONG END
THROTTLE RETURN SPRING
GOVERNOR
ARM BOLT
5 x 12 mm SELF-TAPPING SCREW
2.5 N•m (22 in•lb)
7.3 x 160 mm FUEL TUBE
REASSEMBLY:
Inspect for cracks or deterioration before
installation, and replace if necessary with
low permeation fuel tube.
GOVERNOR
ARM
GOVERNOR ARM
GOVERNOR ARM NUT
10 N•m (7 ft-lb)
B12 TUBE CLIP (2)