Honda HRS216PKA Manual page 120

Hide thumbs Also See for HRS216PKA:
Table of Contents

Advertisement

HRS216PKA • HRS216SKA • HRS216VKA
INSTALLATION
If installing a new Smart Drive cable, fully loosen the cable adjuster before installing the new Smart Drive cable.
1. Route the upper end of the Smart Drive cable through
the hole in the handle pipe until it's visible in the slot in
the top of the handle pipe.
2. Connect the upper end of the Smart Drive cable to
the lower grip bracket.
3. Fit the upper and lower grip brackets together
around the handle pipe slot and secure with the four
4 mm self-tapping screws. The grip brackets will seat
together when properly assembled.
4. Insert the 5 x 37 mm roller pin through the Smart
Drive cable end, and center the pin in the upper and
lower grip bracket slots.
HANDLE PIPE/CABLES
HANDLE
PIPE
SLOT
SMART
DRIVE
CABLE
SMART
DRIVE
CABLE
4 mm SELF-TAPPING
SCREW (4)
Viewed from above
the handle pipe.
SMART DRIVE
CABLE END
5 x 37 mm
Viewed from under
ROLLER PIN
the handle pipe.
CABLE
END
LOWER
GRIP
BRACKET
LOWER GRIP
BRACKET
HANDLE
PIPE SLOT
UPPER GRIP BRACKET
UPPER GRIP BRACKET
LOWER GRIP
BRACKET
10-15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hrs216skaHrs216vka

Table of Contents