Honda HRS216PKA Manual page 50

HRS216PKA • HRS216SKA • HRS216VKA
16. PINION GEAR
SKA AND VKA TYPES
LUBRICATION
1. Remove the wheel bolt and the rear wheel.
2. Remove the wheel washer and the flat washer.
3. Remove the 13 mm circlip, pinion gear collar,
and the pinion gear.
4. Inspect the pinion gear and ratchet key for wear
or damage. Replace as necessary.
5. Apply Honda Marine extreme pressure NLGI #2
GC-LB grease or equivalent to the axle, ratchet
spring, and inside of the pinion gear.
IMPORTANT:
Only use an extreme pressure NLGI #2 GC-LB
wheel bearing grease. Proper application of the
correct grease is critical to ensure proper
operation.
DO NOT USE anti-seize, white lithium, silicone,
WD-40, or any other spray lubricant.
6. Reassemble in the reverse order of
disassembly.

RATCHET
PINION GEAR
KEY

COLLAR
RATCHET
SPRING

AXLE
FLAT WASHER
WHEEL WASHER
REASSEMBLY:
Install the washer as shown.
Install the curved wheel washer
in the direction shown.
MAINTENANCE
PINION GEAR, 12T

Install with the punch
mark facing:
Left - inside
Right - outside
Grease only the inside of the
pinion gears.
PINION GEAR
COLLAR
13 mm
CIRCLIP
WHEEL BOLT
REAR WHEEL
3-17