Honda HRS216PKA Manual page 118

HRS216PKA • HRS216SKA • HRS216VKA
5. Insert the 1/16" drift punch from the bottom to keep the
two holes aligned.
6. From the top side, start the 2 x 12 mm roll pin and
gently tap it in until it is flush with the knob.
5. SMART DRIVE CABLE (VKA TYPE)
REMOVAL
1. Drain the fuel tank.
2. Drain the engine oil.
3. Fully loosen the Smart Drive cable adjuster.
4. Cut the cable tie securing the flywheel brake control cable
to the Smart Drive cable.
HANDLE PIPE/CABLES
2 x 12 mm
ROLL PIN
HANDLE LOCKING KNOB
CABLE TIE
TIGHTEN
1/16" DRIFT PUNCH
ADJUSTER
MARK
JAM
NUT
LOOSEN
10-13