Honda HRS216PKA Manual page 90

HRS216PKA • HRS216SKA • HRS216VKA
OIL PAN REMOVAL
1. Set piston at TDC of compression stroke.
2. Remove the 6 x 25 mm flange bolts
3. Insert a screwdriver or equivalent tool into the recess as
shown, and remove the oil pan from the cylinder block.
Be careful not to damage the sealing surfaces. Use a tool
that fits tightly into the recesses. Twist the tool to break the
sealant loose. Do not drive the tool into the sealing
surfaces with a hammer.
PISTON ASSEMBLY/CONNECTING ROD CAP
INSTALLATION
1. Apply oil to the inner wall of the cylinder and
to the outer surface of the piston.
2. Install the piston assembly in the cylinder so that the model
mark (ZL8, Z8B, or Z2A) by the piston pin hole and the
longer side of the connecting rod big end are at the right
side. (The crankshaft must be at the top dead center of the
compression stroke.)
The model mark on the piston must be positioned toward
the oil pan.
NOTICE
Take care not to break the piston ring when installing the
piston assembly into the cylinder.
3. Apply clean engine oil to the cylinder block crankshaft
bearing area, and install the crankshaft in the cylinder
block.
4. Apply oil to the connecting rod big end bearing and the
crank pin; then connect the connecting rod to the crank pin.
5. Apply oil to the connecting rod cap bearing.
6. Install so that the projection by the oil dipper and the
projection of the connecting rod face in the same direction.
Note that the oil dipper must be on the right- hand side at
this time.
7. Tighten the connecting rod bolts to the specified torque.
TORQUE: 12 N•m (9 ft-lb)
CAM PULLEY/CRANKSHAFT/PISTON/
RECESS
MODEL MARK
OIL DIPPER
CYLINDER BLOCK
CONNECTING
ROD WITH THE
LONG END
PROJECTIONS
9-5