Honda HRS216PKA Manual page 136

HRS216PKA • HRS216SKA • HRS216VKA
15. Install in the reverse order of removal. Pay
attention to the following:
• Be sure to install the 10 mm hardened washer on
the transmission input shaft before assembling
the driven pulley.
• Align the holes in the driven pulley halves when
reassembling the driven pulley.
• Be sure the blade holder Woodruff key is
installed, and does not fall out when installing the
blade holder. It is easy for the key to fall out
during installation. If it is not installed, the blade
holder bolt will eventually break, allowing the
blade and blade holder to fall off during operation.
• Adjust the drive pulley belt guide clearance.
• Readjust the Smart Drive cable (P. 3-9).
TRANSMISSION / DRIVE BELT
(Blade holder shown removed for clarity)
TRANSMISSION DRIVE PULLEY
BELT GUIDE CLEARANCE
3 ~ 4 mm (0.118 ~ 0.157 in)
BELT
DRIVE
PULLEY
BELT GUIDE
12-5