Honda HRS216PKA Manual page 145

TRANSMISSION / DRIVE BELT
10. Install a pinion gear collar and wheel cover.
11. Apply Honda Marine extreme pressure NLGI #2 GC-LB
grease or equivalent to the areas shown.
IMPORTANT:
Only use an extreme pressure NLGI #2 GC-LB wheel
bearing grease. Proper application of the correct grease
is critical to ensure proper operation.
DO NOT USE anti-seize, white lithium, silicon,
WD-40, or any other spray lubricant.
12. Install a ratchet return spring and ratchet key.
13. Install a pinion gear, pinion collar, and 13 mm circlip.
Make sure the pinion gear is installed correctly for each
side as shown.
14. Install a wheel washer, flat washer, wheel, and wheel
bolt.
15. Repeat steps 4 -14 for the left side.
12-14
HRS216PKA • HRS216SKA • HRS216VKA

RATCHET RETURN SPRING
RATCHET KEY
PINION
GEAR
 COLLAR
FLAT WASHER
WHEEL WASHER
REASSEMBLY:
Install the washer as
shown.
WHEEL
SIDE
WHEEL
PINION
COVER
GEAR
COLLAR

12-TOOTH
PINION GEAR
Install with the punch
mark facing:
Left – inside
Right – outside
13 mm
CIRCLIP
WHEEL
BOLT