Honda HRS216PKA Manual page 117

HANDLE PIPE/CABLES
3. HANDLE GRIP REMOVAL /
INSTALLATION (VKA TYPE)
1. Remove the following, depending on the grip that
needs replacement:
• Smart Drive cable
• Flywheel brake cable
• 6 mm locking pin and rope guide
2. Remove the handle pipe from the handle stays
(P. 10-2).
3. Remove the old grip(s).
4. Lubricate the inside of the handle grip with soapy
water.
5. Slide the grips onto the handle pipe.
The grips should be 45 ~ 50 mm from the Smart Drive
control as shown.
6. Reassemble the handle pipe and install the handle
pipe to the handle stays.
4. HANDLE LOCKING KNOB (K6 TYPES)
REMOVAL
1. Drive the 2 x 12 mm roll pin out with a 1/16" drift punch.
2. Separate the parts as shown.
INSTALLATION
1. Insert the height adjusting collar into the lower
mounting hole in the handle so that the flat part is
resting against the handle.
2. Slide the spring over the 8 mm pin.
3. Insert the pin into the collar and push it through until
you can see the hole in the pin on the other side.
4. Install the handle locking knob onto the top of the pin
and line up the holes on the pin and the knob.
10-12
(P. 10-13)
(P. 10-2)
(P. 10-2)
HRS216PKA • HRS216SKA • HRS216VKA
HANDLE
45 ~ 50 mm
GRIP (2)
(1.75 ~ 2.0 in)
1/16" DRIFT PUNCH
LOWER
MOUNTING
HOLE
8 mm PIN
HEIGHT
ADJUSTING
SPRING
HEIGHT
ADJUSTING
2 x 12 mm
COLLAR
ROLL PIN
SMART DRIVE
CONTROL
™
CONTROL
MULTI-POSITION
ADJUSTER
HANDLE
LOCKING
KNOB
2 x 12 mm
ROLL PIN
HANDLE
LOCKING
KNOB