Honda HRS216PKA Manual page 114

HRS216PKA • HRS216SKA • HRS216VKA
K6 VKA MODEL
This procedure explains the removal and installation for both
left and right handle stays. If only replacing one handle stay,
follow the instructions for only that side.
1. Release the handlebar locking knobs and fold the
handle pipe assembly over the top of the mower in the
storage/transportation position.
2. Remove the two special bolts and nylon washers
release the handle pipe assembly from the handle
stays.
3. Remove the rear scroll
4. Remove the wheel bolt, wheel, wheel washer, and
flat washer from each side.
5. Remove the 13 mm circlip, pinion gear collar, pinion
gear, ratchet key, and ratchet return spring from each
side.
(P. 11-2).
HANDLE PIPE/CABLES
HANDLE STAY
(left side shown)
FLAT WASHER
WHEEL WASHER
RATCHET RETURN SPRING
PINION
GEAR
COLLAR
NYLON WASHER (2)
SPECIAL
BOLT (2)
HANDLE
LOCKING
KNOB (2)
WHEEL
BOLT
RATCHET KEY
12-TOOTH
PINION GEAR
13 mm
CIRCLIP
10-9