Honda HRS216PKA Manual page 88

HRS216PKA • HRS216SKA • HRS216VKA
3. Apply oil to the O-ring and install it on the cam pulley
shaft.
4. Install the cam pulley shaft in the cylinder block.
5. Hold the cam pulley alignment marks in line with the
cylinder head cover mating surface. Check again that the
crankshaft key groove is facing up.
6. If the long key groove is not facing up, repeat the
procedure from step 1.
ROCKER ARM SHAFT INSTALLATION
Install the rocker arm shaft from the opposite side of the cam
pulley as shown.
CYLINDER HEAD COVER INSTALLATION
1. Clean the mating surface of the cylinder block using a
de-greasing cleaning agent and a clean shop towel.
2. Apply liquid gasket (Hondabond HT, ThreeBond 1216,
®
Loctite 5900, or equivalent) to a new cylinder head cover,
specifically to the inner wall of the groove and bolt hole in
the cylinder head cover.
Assemble within 10 minutes after applying the liquid
gasket.
3. Wait for at least 20 minutes after assembly before filling
with oil and starting the engine.
CAM PULLEY/CRANKSHAFT/PISTON/
CAM PULLEY
CAM PULLEY
SHAFT

O-RING,
6.8 x 1.9 mm
ROCKER ARM SHAFT
CYLINDER HEAD COVER VIEWED FROM BACK SIDE
(New)
CYLINDER BLOCK
TIMING BELT
LIQUID GASKET
APPLICATION
AREA
9-3