Honda HRS216PKA Manual page 144

HRS216PKA • HRS216SKA • HRS216VKA
K6 VKA MODEL
1. Position the 25 mm circlips and 26 x 36mm washers on
each side of the transmission axle as shown.
2. Rotate the transmission so that the pulley is facing
toward the front of the mower, and install the
transmission into the mower deck/handle stays.
3. Inspect the adjuster arm bushings and seals for wear
and replace if necessary.
4. Inspect the bushing contact areas on the axle for
roughness or debris. If necessary, thoroughly clean the
bushing contact areas on the axle using a
Scotch-Brite™ pad.
5. Thoroughly apply a coat of Honda Marine extreme
pressure NLGI #2 GC-LB grease or equivalent INSIDE
the adjuster arms and on the axle surfaces.
IMPORTANT:
Only use an extreme pressure NLGI #2 GC-LB wheel
bearing grease. Proper application of the correct grease
is critical to ensure proper operation.
DO NOT USE anti-seize, white lithium, silicon,
WD-40, or any other spray lubricant.
6. Slide the adjuster plate onto the right side adjusting
arm.
7. Install the right side adjuster assembly, taking care not
to damage the seals.
8. Slide a 26 x 36 mm washer onto the adjuster arm and
secure with a 25 mm circlip.
9. Install a thrust collar and 13 mm washer, and secure
with a 13 mm circlip.
TRANSMISSION / DRIVE BELT
ADJUSTER ARM
ADJUSTER
PLATE
26 x 36 mm
WASHER
25 mm
CIRCLIP

Clean bushing
contact areas with a
Scotch-Brite™ pad.
THRUST
COLLAR
13 mm
WASHER
13 mm
CIRCLIP
12-13