Honda HRS216PKA Manual page 74

Hide thumbs Also See for HRS216PKA:
Table of Contents

Advertisement

HRS216PKA • HRS216SKA • HRS216VKA
Choke Assembly Installation
1. Install the choke assembly when the cylinder head
temperature is less than 40 °C (104 °F).
2. Apply a small amount of Hondabond HT to the bottom and
lower third of the new thermowax. Do not apply too much.
3. Install the thermowax assembly into the cylinder barrel.
Remove any excess Hondabond HT if it comes out from
around the thermowax.
4. Inspect the choke control for proper operation
5. Verify that the carburetor choke lever is in the fully closed
position.
6. Install the carburetor and choke assembly
6. After installation, verify that there is clearance between choke
lever A and the carburetor choke lever. Push on choke lever A
and confirm it moves freely and springs back when released.
BREATHER TUBE
Installation
Connect the end with the white mark to the breather cover hole as
shown. Connect the other end to the air cleaner case.
(page
2-23).
THERMOWAX ASSEMBLY
(page
7-2).
HONDABOND HT
CHOKE LEVER A
Air cleaner case not shown for clarity
CLEARANCE
CARBURETOR
EXISTS
CHOKE LEVER
WHITE
MARK
BREATHER
BREATHER
TUBE
COVER
FUEL SYSTEM
CHOKE
ASSEMBLY
INSULATOR
GASKET
Replace.
7-15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hrs216skaHrs216vka

Table of Contents