Sysmac Studio; Connection Method And Procedures - Omron PROFINET NX-PNC202 User Manual

2-3

Sysmac Studio

This section describes the Sysmac Studio that is used to set up the Profinet IO Device Terminal.
2-3-1

Connection Method and Procedures

This section describes the method and procedures that are used to connect the Sysmac Studio to a
Profinet IO Device Terminal. The Sysmac Studio is connected to a USB port of a PROFINET Coupler
Unit as an example. For Support Software other than the Sysmac Studio, refer to the operation manual
for the Support Software that you are using.
Going Online through the USB Port on the PROFINET Coupler Unit
 Connection Methods
You can place the Sysmac Studio online with the Profinet IO Device Terminal.
Connect the PC USB port to the USB port on the PROFINET Coupler Unit.
 Connection Procedure
Use the following procedure to place the Sysmac Studio online.
1
Connect the PROFINET Coupler Unit to a computer on which the Sysmac Studio is installed
through a USB cable.
2
Create a new project with the following settings.
Category: Slave terminal
Device: PROFINET Coupler
Refer to 9-2-2 Setting the NX Unit Configuration Information on page 9-5 for the procedures to
create the Unit configuration information.
3
Right-click the PROFINET Coupler Unit in the Edit Profinet IO Device Terminal Configuration
Tab Page, and select Coupler Connection (USB)  Online. Or, right-click the PROFINET Cou-
pler Unit in the Multiview Explorer and select Coupler Connection (USB)  Online.
A confirmation dialog box is displayed.
4
Click the OK button.
The Sysmac Studio goes online with the Profinet IO Device Terminal.
NX-series PROFINET Coupler Unit User's Manual (W623)
2 Features and System Configuration
2
2 - 9