Using Settings From Nx Units On Other Coupler Units - Omron PROFINET NX-PNC202 User Manual

Additional Information
• Refer to the manual for the specific NX Unit for the procedures to mount and remove the NX
Unit.
• Refer to Precautions for Safe Use on page 16 for the procedures to disconnect and connect
the PROFINET Coupler Unit from and to the PROFINET network.

13-2-4 Using Settings from NX Units on Other Coupler Units

To mount and use NX Units that were set for one IO Device Terminal under a different PROFINET Cou-
pler Unit, you must export and import NX Unit settings.
To use the NX Unit settings on a different IO Device Terminal, you must export the NX Unit settings
from the Unit configuration of the set IO Device Terminal and then import the settings to the Unit config-
uration of the newly mounted IO Device Terminal.
Additional Information
• Refer to 9-2-5 Sysmac Studio Functions Used as Required on page 9-12 for information on
exporting and importing NX Unit settings.
• Some of the NX Unit settings are saved in the PROFINET Coupler Unit. Therefore, even if
you upload the NX Unit settings to an NX Unit that was set on a different IO Device Terminal,
the original NX Unit settings are not correctly applied to the newly mounted IO Device Termi-
nal. If you want to use the set NX Unit by mounting it to another IO Device Terminal, transfer
the Unit operation settings to the relevant NX Unit.
NX-series PROFINET Coupler Unit User's Manual (W623)
13 Maintenance and Inspection
13
13 - 7