Kyocera TASKalfa Pro 15000c Installation Manual page 70

The main unit setup procedure > Adjustment
U469 Head overlap adjustment (If it is necessary to adjust.)
1
Set the maximum sized paper such as over A3/Ledger paper.
2
Select [Head Overlap] in U469 Adj Cor Reg.
3
Select [Print] and press [Start] key.
Print head overlap width adjustment chart is output.
NOTE
In case if Yellow color is not visible on the chart, copy the chart by the following procedure.
[Color/Image quality] > [Hue Adjust] > select [Individual] > select [Yellow] of Hue circle and shift to "Red" side 3
times and then press [OK] to make copy.
[Yellow] section becomes [Green] so that distinguish with that condition.
Or, using the UV light (Black light) sold commercially available in the market which makes easier to view Yellow.
4
<The below shows the example: sample CH2>
Check the position of the number where the gap is not available (Red arrow position)
and confirm the number two below the number checked.
5
Select [Regist] to get the below screen and select each item and change the setting
value.
Head Overlap
MH-1
01
MH-2
02
CH-1
03
CH-2
04
KH-1
05
KH-2
06
YH-1
07
YH-2
08
6
Press [Start] key to set the setting value.
U469
0
0
CH-2
0
5
0
0
0
0
2-54
[CONFIDENTIAL]