Kyocera TASKalfa Pro 15000c Installation Manual page 136

Enhancement device setup procedure > Optional device installation
<C> Bridge kit for paper feeder (AK-9130) to Paper feeder (PF-9100)
NOTE
• Up to 2 units of paper feeder PF-9100 can be connected by installing a bridge kit for paper feeder AK-9130
between them.
• In this manual, PF-9100 that is closer to main unit, is defined as 1st or downstream unit and further from main
unit is 2nd or upstream unit.
• See Bridge Kit for Paper Feeder (AK-9130)
CAUTION
• Make sure that the main power switch and AC power switch of the main machine are turned OFF and that its
power cord is disconnected before doing the following procedure.
Preparation for Horizontal Transport Unit into downstream Paper feeder (PF-9100)
NOTE
• Attaching position of the four units
• [A]: Detent unit
• [B]: Entrance motor unit
• [C]: Exit motor unit
• [D]: Control board
for unpacking.
3-58
[CONFIDENTIAL]