Kyocera TASKalfa Pro 15000c Installation Manual page 247

Enhancement device setup procedure > Optional device installation
94
At the front right corner, remove the screw of the lock bar [A] (screw x1), and pull the
lock bar toward you until it stops. Use this screw in Step 94.
95
Slowly push the high capacity stacker [B] against the left side of the upstream unit so
that the lock bar is directly and squarely under the arms of the joint bracket [C].
96
Push the lock bar in completely so that it slides up into the notches in the arms on
both ends of the joint bracket, and fasten the lock bar by re-attaching the screw
removed in Step 92 (screw x1).
97
Attach the I/F cable [D] to the upstream unit.
98
Re-attach the front right cover.
99
Fasten left lock hasp [A] (screw x2: M4x8) to the door. Fasten right lock hasp [B] to
the door frame (screw x2: M3x6).
3-169
[CONFIDENTIAL]