Enhancement device setup procedure > Optional device installation
NOTE
There is no switch for dehumidifier heater so that it is always on while power cable of paper feeder plug in
power source. In case of turning heater off, relay connector [A] has to be disconnected.
This step would not be necessary, if customer agree to use the heater.
38
Remove the ground plate [A] (Screw x2). Change the orientation of the ground plate
[A], and then install it as shown below (Screw x2).
39
Attach the cushion [A] to the docking side of the paper feeder as shown below.
40
Connect PF-9100 and AK-9110.
3-53
[CONFIDENTIAL]