Kyocera TASKalfa Pro 15000c Installation Manual page 287

Enhancement device setup procedure > Optional device installation
30
Close the front Lower cover [A] of DF-9100. Close the front upper cover [B].
[A]
Adjustment of booklet stapling position
Check the distance [A] from center to staple. If the distance [A] is out of specification, then adjust it as following
procedure.
<Specification [A]> +/-2 mm
1
Select [Booklet], [Staple Pos] in Maintenance mode U246.
2
Select setting values.
3
Press [Start] key to set the setting value.
Adjustment of center folding position
Check the distance [B] from edge to folding position. If the distance [B] is out of specification, then adjust it as following
procedure.
<Specification [B]>
A4, Letter: Paper length x1/2 +/-2 mm
A3, Ledger, B4: Paper length x1/2 +/-3 mm
1
Select [Booklet], [Staple Pos] in Maintenance mode U246.
[B]
[A]
[B]
3-209
[A]
[CONFIDENTIAL]