The main unit setup procedure > Ink initial supply (Set up flow)
12
(Display: MANU0104) Make sure to check all the couplings [A] are connected and the
clamps [B] are closed again.
•
Confirm if the ink is flowing into the tube of supply side.
•
Select [Execute] and press [Start] to continue.
13
(Display: AUTO0105) Perform print head set up.
•
After starting the syringe supply, the level sensor in the sub ink tank detects the ink in the filter circulation.
(It takes about 40 minutes.)
•
Select [Execute] and press [Start] to run job.
•
If error code is displayed, check the list and perform necessary action. (See
Then select [execute] and press [start] to return step 12.
IMPORTANT
If service call error C2260 occurs, check the position of the unit with the following link and shift it to the Page
position.
C2260: Head maintenance sensor error (See
14
(Display: FINISH) Complete ink installation
15
Reattach the bracket rear cover [A] to the original position. (Screw x2)
Attach with attention for direction and damage.
page 5-8
for the corrective action of service call)
2-41
[CONFIDENTIAL]
page
5-15)