Kyocera TASKalfa Pro 15000c Installation Manual page 379

Machine transportation after setup > Procedure for the main unit transportation (Truck transportation)
55
Check if all the clamps [A] and the couplings [B] of Y, K, C, M, CL in ink unit are open.
• If they close, open them refer to below.
Open
56
Connect the power cable [C] to the main unit [A].
57
Open the front right lower cover [B] and turn the main SW [D] on.
58
Close the lower right front cover.
59
Enter maintenance mode.
60
(Display: Begin) Select [Simple Ink Inst], [Execute] in U740 Set UP and press [Start]
key.
IMPORTANT
Any modes are prohibit in U740 Set Up, so that power off does not allow to exit from this mode unless complete
all routine.
61
Display [Step] and [Execute].
IMPORTANT
1 Follow the work flow by checking number on display [Auto xxx (Run automatically)] or [Manu xxx (Manual
procedure)].
2 Select [Execute] after completing the steps, then press [Start] key to continue. (Change the number with
Auto or Manu to the next.)
3 If [Undo] comes up with incomplete, check previous procedure.
[A]
[B]
[A]
[B]
[D]
6-49
[CONFIDENTIAL]
Open Close
[C]